Electrical Connection - Zanussi ZEI3921IBA Benutzerinformation

• Do not install the appliance adjacent to a
door or under a window. This prevents hot
cookware to fall from the appliance when the
door or the window is opened.
• If the appliance is installed above drawers
make sure that the space, between the
bottom of the appliance and the upper
drawer, is sufficient for air circulation.
• The bottom of the appliance can get hot.
Make sure to install a non-combustible
separation panel under the appliance to
prevent access to the bottom.
• Make sure that the ventilation space of 2
mm, between the worktop and the front of
the below unit, is free. The warranty does not
cover damages caused by the lack of an
adequate ventilation space.

Electrical Connection

WARNING!
Risk of fire and electrical shock.
• All electrical connections should be made by
a qualified electrician.
• The appliance must be earthed.
• Before carrying out any operation make sure
that the appliance is disconnected from the
power supply.
• Make sure that the electrical information on
the rating plate agrees with the power
supply. If not, contact an electrician.
• Make sure the appliance is installed
correctly. Loose and incorrect electricity
mains cable or plug (if applicable) can make
the terminal become too hot.
• Use the correct electricity mains cable.
• Do not let the electricity mains cable tangle.
• Make sure that a shock protection is
installed.
• Use the strain relief clamp on the cable.
• Make sure the mains cable or plug (if
applicable) does not touch the hot appliance
or hot cookware, when you connect the
appliance to the near sockets
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
mains plug (if applicable) or to the mains
cable. Contact our Authorised Service
Centre or an electrician to change a
damaged mains cable.
• The shock protection of live and insulated
parts must be fastened in such a way that it
cannot be removed without tools.
4
All manuals and user guides at all-guides.com
• Connect the mains plug to the mains socket
• If the mains socket is loose, do not connect
• Do not pull the mains cable to disconnect
• Use only correct isolation devices: line
• The electrical installation must have an
Use
• Remove all the packaging, labelling and
• Use this appliance in a household
• Do not change the specification of this
• Make sure that the ventilation openings are
• Do not let the appliance stay unattended
• Set the cooking zone to "off" after each use.
• Do not rely on the pan detector.
• Do not put cutlery or saucepan lids on the
• Do not operate the appliance with wet hands
• Do not use the appliance as a work surface
• If the surface of the appliance is cracked,
• Users with a pacemaker must keep a
• When you place food into hot oil, it may
only at the end of the installation. Make sure
that there is access to the mains plug after
the installation.
the mains plug.
the appliance. Always pull the mains plug.
protecting cut-outs, fuses (screw type fuses
removed from the holder), earth leakage trips
and contactors.
isolation device which lets you disconnect
the appliance from the mains at all poles.
The isolation device must have a contact
opening width of minimum 3 mm.
WARNING!
Risk of injury, burns and electrical
shock.
protective film (if applicable) before first use.
environment.
appliance.
not blocked.
during operation.
cooking zones. They can become hot.
or when it has contact with water.
or as a storage surface.
disconnect immediately the appliance from
the power supply. This to prevent an
electrical shock.
distance of minimum 30 cm from the
induction cooking zones when the appliance
is in operation.
splash.
WARNING!
Risk of fire and explosion
www.zanussi.com