Safety Instructions; Electrical Connection - Zanussi ZEI3921IBA Benutzerinformation

Unattended cooking on a hob with fat or oil can be dangerous
•
and may result in fire.
Never try to extinguish a fire with water, but switch off the
•
appliance and then cover flame e.g. with a lid or a fire blanket.
Do not store items on the cooking surfaces.
•
Metallic objects such as knives, forks, spoons and lids should
•
not be placed on the hob surface since they can get hot.
Do not use a steam cleaner to clean the appliance.
•
After use, switch off the hob element by its control and do not
•
rely on the pan detector.
If the glass ceramic surface / glass surface is cracked, switch
•
off the appliance to avoid the possibility of electric shock.
If the supply cord is damaged, it must be replaced by the
•
manufacturer, an authorized Service or similarly qualified
persons in order to avoid a hazard.

Safety instructions

Installation
WARNING!
Only a qualified person must install
this appliance.
• Remove all the packaging.
• Do not install or use a damaged appliance.
• Obey the installation instruction supplied
with the appliance.
• Keep the minimum distance from the other
appliances and units.
• Always be careful when you move the
appliance because it is heavy. Always wear
safety gloves.
• Seal the cut surfaces with a sealant to
prevent moisture to cause swelling.
• Protect the bottom of the appliance from
steam and moisture.
• Do not install the appliance adjacent to a
door or under a window. This prevents hot
cookware to fall from the appliance when the
door or the window is opened.
• If the appliance is installed above drawers
make sure that the space, between the
bottom of the appliance and the upper
drawer, is sufficient for air circulation.
• The bottom of the appliance can get hot.
Make sure to install a non-combustile
14
separation panel under the appliance to
prevent access to the bottom.
• Make sure that the ventilation space of 2
mm, between the worktop and the front of
the below unit, is free. The warranty does not
cover damages caused by the lack of an
adequate ventilation space.

Electrical Connection

WARNING!
Risk of fire and electrical shock.
• All electrical connections should be made by
a qualified electrician.
• The appliance must be earthed.
• Before carrying out any operation make sure
that the appliance is disconnected from the
power supply.
• Make sure that the electrical information on
the rating plate agrees with the power
supply. If not, contact an electrician.
• Make sure the appliance is installed
correctly. Loose and incorrect electricity
mains cable or plug (if applicable) can make
the terminal become too hot.
• Use the correct electricity mains cable.
• Do not let the electricity mains cable tangle.
• Make sure that a shock protection is
installed.
• Use the strain relief clamp on the cable.
www.zanussi.com