Before The Installation; Connection Cable - Zanussi ZEI3921IBA Benutzerinformation

Before the installation

Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.

Connection cable

• The hob is supplied with a connection cable.
• To replace the damaged mains cable use
the following (or higher) mains cable type:
H05V2V2-F Tmax 90°C. Speak to your local
Service Centre.
Assembly
20
Installation of more than one hob
min. 650 mm
If several 30 cm hobs are to be installed side by
side into the same cut out, an assembly kit
including a support side bracket and
supplementary seals is available at our
Authorised Service Centres. The relevant
installation instructions are supplied within the
kit package.
A
< 20 mm
min. 250 mm
A B
12 mm 57 mm
28 mm 41 mm
38 mm 31 mm
490 mm
270 mm
min. 2 mm
B
min
30 mm
www.zanussi.com