Topdon BT300P Bedienungsanleitung Seite 7

3. Charging Test (12V&24V)
3.1 Before Test
The engine must be ON during test in order to have results.
Ensure all electrical accessories and devices remain in the
OFF state.
*Turning ON/OFF any electrical accessories in the vehicle
during the test will affect the accuracy of the test result.
3.2 Steps
1) The RED (+) Positive Battery Clamp is connected to the (+)
positive battery terminal, and the BLACK (-) Negative Battery
Clamp is connected to the (-) negative battery terminal.
Ensure that the clamps have a firm, secure grip on the
battery terminals for accurate results.
2)The device will jump to main menu automatically after 3
seconds, then select "CHARGING TEST":
MAIN MENU
BATTERY TEST
CRANKING TEST
CHARGING TEST
REVIEW DATA
LANGUAGE
9
3) Press "ENTER/PRINT" to enter the "RIPPLE TEST" interface:
RIPPLE TEST
4) Press "ENTER/PRINT" again, or wait for a few seconds to
enter the "CHARGING TEST" interface:
CHARGING TEST
INCREASE SPEED
TO 2500 R/MIN. KEEP
IT FOR 5 SECONDS.
PRESS ENTER TO
CONTINUE.
5) The tester prompts the operator to "Increase RPM to
2500r/min and keep it 5 seconds". Press "ENTER/PRINT" to
get the test result:
For 12V battery
CHARGING TEST
CHARGING
LOADED
UNLOADED
RIPPLE
12.98V
V LOW
V 12.20 V
V 12.47V
V 5mV
10