Operation; Maintenance; Cleaning - Maico ECA 100 ipro Montage- Und Betriebsanleitung

9 Operation

6 Cover
7 Designer cover
1. Carefully remove designer cover
11 Setting button for start delay
12 Setting button for overrun time
2. Setting the start delay: Press the left setting
button repeatedly, until the LED of the desired
start delay time lights up. Wait until the LED
flashes twice and goes out. The value is now
saved.
3. Setting overrun time: Press the right setting
button repeatedly, until the LED of the desired
overrun time lights up. Wait until the LED
flashes twice and goes out. The value is now
saved.
The settings take effect starting with the
next switching process (sensor, light switch).
4. Fit designer cover.
26
9 Operation
Fan is turned on/off using a switch (e.g. light
switch). Depending on the unit variant with start
delay, with H and B units operation is automatic
or controlled with an additional switch.

10 Maintenance

The unit is maintenance-free.

11 Cleaning

Clean fan regularly, especially after it has
not been used for a long time.
NOTICE Risk of damage to unit if incorrect
cleaning agent is used.
Only clean the cover using water.
Do not use aggressive cleaning agents.
NOTICE Lamellae may break if cleaned incor-
rectly.
Be careful when cleaning them.
Do not open, close or bend the lamellae too
much.
1. Only use a dry cloth to clean the internal parts
of the fan.
2. If the cover is very dirty, carefully remove it
and clean with water.
3. Attach cover, switch on mains fuse, remove
warning sign and carry out function test.