Care Instructions; Storage Instructions - Medi Stabimed RICE Gebrauchsanweisung

English
leg so that the lower edge of the hole
for the kneecap is sitting on the lower
side of the kneecap and is positioned
centrally (Fig. 2).
• Now position both of the joints on the
brace. To do this, put the joint splints in
the small attached hook-and-loop
pockets (Fig. 3).
• Now stick the splints onto the side of
the brace. Ensure that the brace joints
are in the correct position: The middle
of the brace joints should be level with
the top of the kneecap (Fig. 4). The
joints must be positioned behind the
centre of the side of the leg and must
run parallel to each other. The joints
must be adapted to the patient's
individual leg shape by limiting them.
• Wrap both straps around the leg and
close the straps on the brace (Fig. 5).
• If the straps are too short, simply
fasten both of the additional strap
extensions on the hook-and-loop areas
at the ends of the straps for the brace
(Fig. 6). You can now wrap the straps
around the leg as usual and fasten
them on the brace.

Care instructions

Please close the hook and loop fasteners
before washing and remove the splint.
Switch the valve to "OFF". We
recommend using a laundry bag. Soap
residues, lotions and ointments can
cause skin irritation and material wear.
The cooling compress can be cleaned
carefully with water, a moistened towel
or a sponge.
• Wash the product by hand, preferably
using a medi clean detergent, or in
delicate cycle at 30°C using a mild
detergent without fabric conditioners.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.
    

Storage instructions

Keep the product in a dry place and do
not expose to direct sunlight.
Material composition
Knee sleeve: Cotton, nylon
Blow-up inner cushion: Polyester, nylon
Air pump: Silicone, polyethene, synthetic
rubber
Cooling compress: Propylene glycol,
sodium carboxymethyl cellulose, water
Joints: Aluminium, polyester
Liability
The manufacturer's liability will become
void if the product is not used as
intended. Please also refer to the
corresponding safety information and
instructions in this manual.
Disposal
The product can be disposed of
in the domestic waste.
In the event of any complaints regarding
the product such as damage to the fabric
or a fault in the fit, please report to your
specialist medical retailer directly. Only
serious incidents which could lead to a
significant deterioration in health or to
death are to be reported to the
manufacturer or the relevant authorities
in the EU member state. The criteria for
serious incidents are defined in Section
2, No. 65 of the Regulation (EU) 2017/745
(MDR). The traceability of this product is
assured via a UDI code
Note on additional functions of the
brace
The brace can also be used with a
cooling compress and/or with compres-
sion with the aid of an additional air
pump, dependent on the instructions of
the doctor.
.