Heating Recommendations; Extinguishing The Fire - Dovre TAI 45C Gebrauchsanweisung

Be careful not to smother the fire by adding too
much coal at once.
You have added as much as you can when the
glow from the previous load is only just visible.
6. Close the door.
7. Allow the coal to burn well for a few minutes and
then set the thermostat to the desired position.
If the coal basket begins to glow red, the fire is
burning too strongly.
Burning coal with bunker
After you have followed the instructions for lighting:
1. Open the primary air slide (thermostat) all the way.
2. Slowly open the door of the appliance.
3. Spread the charcoal evenly across the bottom of
the stove base.
4. Close the door.
5. Slowly open the filling panel in the top plate.
6. Fill the bunker with coal to below the rearmost air
openings in the bunker.
7. Close the filling lid.
8. Allow the coal to burn well for a few minutes and
then set the thermostat to the desired position.
The filling frequency depends on the output
demanded.
To keep the stove burning at night, the ther-
mostat is turned down to around position 1.
Subject to change because of technical improvements
The correct position depends on the flue and
the weather conditions.
If the coal basket begins to glow red, the fire is
burning too strongly.

Heating recommendations

Never burn wood with an open door.
Regularly burn wood with intense roaring fires.
If you burn at a low setting frequently, tar and
creosote may be deposited in the flue. Tar and
creosote are highly combustible substances.
Thicker layers of these substances may catch
fire if the temperature in the flue increases sud-
denly. By allowing the fire to burn very
intensely regularly, layers of tar and creosote
will disappear.
Low intensity fires can also cause tar deposits
on the stove window and door.
When the outside temperature is mild, it is bet-
ter to burn wood intensely for a few hours
instead of having a low intensity fire for a long
period of time.
Regulate the air supply using the secondary air
inlet (only when burning wood).
The secondary air inlet not only supplies air to
the fire but to the glass as well, so that it does
not quickly become dirty.
Open the primary air inlet for the time being if the air
supply by the secondary air inlet is inadequate or if
you want to fan the fire.
09-20020-359
Topping up with a few logs regularly is better than
adding many logs in one go.
Regularly adding small amounts of brown coal bri-
quettes or anthracite coal is better than adding a
large amount of brown coal briquettes or anthracite
coal in one go.

Extinguishing the fire

Do not add fuel and just let the fire go out. If a fire is
damped down by reducing the air supply, harmful sub-
stances will be released. For this reason, the fire
should be allowed to go out naturally. Keep an eye on
19