Specifications; Spare Parts And Accessories - Stihl HSA 45 Gebrauchsanleitung

18 Specifications

Fault LEDs on
hedge trimmer
Hedge trimmer is 3 LEDs light
not charging. up in red.
18 Specifications
18.1 STIHL HSA 45 Hedge Trimmer
– Weight with cutting blades: 2.3 kg
– Battery technology: lithium-ion
– Voltage: 18 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Permissible temperature range for operation
and storage: 0°C up to 50°C
If the hedge trimmer is used at temperatures
higher than 30°C, the battery runtime may be
shortened and the trimmer's performance
reduced.
For runtime, see www.stihl.com/battery-life.
18.2 Cutting Blades
– Tooth spacing: 24.1 mm
– Cutting length: 500 mm
– Sharpening angle: 32°
18.3 STIHL LK 45 Charging Cable
– Voltage: 100-240 V, 50‑-60 Hz
– Power rating: 14.6 W
– Charge current: 0.65 A
– Permissible temperature range for operation
and storage: 0°C up to 40 °C
For charging times see www.stihl.com/charging-
times.
18.4 Sound Values and Vibration
Values
The K-value for the sound pressure levels is
2 dB(A). The K-value for the sound power levels
is 2 dB(A). K-value for vibration level is 2 m/s².
STIHL recommends wearing ear defenders.
– Sound pressure level L
to EN 60745-2-15: 75 dB(A).
– Sound power level L
EN 60745-2-15: 83 dB(A).
– Vibration level a measured as specified in
hv
EN 60745-2-15
– Control handle: 1.5 m/s². The K value for
the vibration level is 1.5 m/s².
– Loop handle: 1.4 m/s².
0458-717-9821-C
Cause
Hedge trimmer is too
hot.
Malfunction in hedge
trimmer or charging
cable.
measured according
p
measured according to
wA
Remedy
► Remove activation key.
► Allow the hedge trimmer to cool down.
► Remove activation key.
► Contact a STIHL servicing dealer.
The vibration levels indicated were measured
according to a standardized test method and can
be used as a basis for comparing electric power
tools. The vibration levels actually occurring may
vary from the values indicated, depending on the
type of application. The vibration levels indicated
can be used for an initial estimate of the vibration
stress. The actual vibration stress has to be esti‐
mated. The times can be taken into account in
the estimate when the electric power tool is
turned off and also when it is turned on but run‐
ning under no load.
For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
18.5 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
19 Spare Parts and Accesso‐
ries
19.1

Spare parts and accessories

These symbols indicate original STIHL
spare parts and original STIHL acces‐
sories.
STIHL recommends the use of original STIHL
spare parts and accessories.
Despite ongoing market observation, STIHL is
unable to judge the reliability, safety and suitabil‐
ity of other manufacturers' spare parts and
accessories; accordingly, STIHL cannot warrant
for the use of those parts.
Original STIHL spare parts and original STIHL
accessories are available from STIHL dealers.
English
33