AEG BS18C3BL Originalbetriebsanleitung Seite 19

SPECIFIED CONDITIONS OF USE
drilling and screwdriving.
Do not use the product for any other purpose.
ADDITIONAL BATTERY SAFETY WARNINGS
Warning!
damage due to a short circuit, never immerse your tool, battery pack
bleach or bleach containing products, etc., can cause a short circuit.
Do not dispose of used battery packs in the household refuse or by
our environment.
Use only AEG chargers for charging AEG battery packs. Do not use
battery packs from other systems.
Never break open battery packs and chargers and store them only in
dry rooms. Keep the battery pack dry at all times.
Battery packs that have not been used for some time should be
recharged before use.
Temperatures in excess of 50°C (122°F) reduce the performance of
the battery pack. Avoid extended exposure to heat or sunshine (risk of
overheating).
The contacts of chargers and battery packs must be kept clean.
For an optimum life-time, the battery packs have to be fully charged,
after used.
To obtain the longest possible battery life remove the battery pack from
the charger once it is fully charged.
For battery pack storage longer than 30 days:
Store the battery pack where the temperature is below 27°C and away
from moisture.
Store the battery packs in a 30% - 50% charged condition.
Every six months of storage, charge the pack as normal.
BATTERY PACK PROTECTION
The battery pack has overload protection that protects it from being
overloaded and helps to ensure long life.
product does not start up again, the battery pack may have discharged
completely. Recharge the battery pack.
TRANSPORTING LITHIUM BATTERIES
Lithium-ion batteries are subject to the Dangerous Goods Legislation
requirements.
Transportation of those batteries has to be done in accordance with
local, national and international provisions and regulations.
• Batteries can be transported by road without further requirement.
• Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation and
transport are exclusively to be carried out by appropriately trained
persons and the process has to be accompanied by corresponding
experts.
• Ensure that the battery contact terminals are protected and insulated
to prevent short circuit.
• Ensure that the battery pack is secured against movement within the
packaging.
• Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.
MAINTENANCE
Use only AEG accessories and spare parts. Should components that
have not been described need to be replaced, contact one of our AEG
If needed, an exploded view of the product can be ordered. State the
product type and the serial number printed on the label, and order the
drawing at your local service agents or directly at: Techtronic Industries
GmbH, Max-Eyth-Straße 10, 71364 Winnenden, Germany.
SYMBOLS
CAUTION! WARNING! DANGER!
Remove the battery pack before starting any work on
the product.
Read the instructions carefully before starting the
product.
batteries together with household waste material.
Electric tools and batteries that have reached the end
of their life must be collected separately and returned to
an environmentally compatible recycling facility. Check
with your local authority or retailer for recycling advice
and collection point.
No-load speed
V
Volts
Direct current
European Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
ENGLISH 19