Settings; Saw Band Tension; Saw Band Guide; Adjustment - HOLZMANN-MASCHINEN BS320TOP Betriebsanleitung

16.3 Settings

16.3.1 Saw band tension

16.3.1 Saw band guide

HOLZMANN MASCHINEN GmbH
The saw band guide should be close to the workpiece.
This helps to ensure a clean cut.
The following steps are necessary:
 Loosen the screw (3) with an allen key.
 Push the saw band guide with the handle (4) into the
desired position.
 Retighten the screw (3) with the allen key.

Adjustment

The saw band guide (7) is preset for a saw band with a
thickness of 0.9 mm.
However, if the saw band guide needs to be adjusted,
the following setting should be carried out:
 The lateral bearings of the saw band guide (7) can
be adjusted by loosening the screw (5) and the
adjusting screw (6).
 Adjust the bearings so that the saw band can slide
smoothly and there is a gap of approx. 0.05mm
between the bearings and the saw band.
 Retighten the screw (5).
 Loosen the screws (8) and adjust the upper saw
band guide (7).
 Check that there is at least 0.2-0.3 mm space
between the saw band and the upper bearing.
www.holzmann-maschinen.at
 In an emergency you can stop all machine
functions immediately by pressing the
EMERGENCY STOP switch (26).
Correct saw band tension is essential for a long
life of the saw band and to ensure the quality of
the cut.
 For this purpose the saw band tension must
be adjusted with the hand wheel (1).
 The correct saw band tension is achieved
when the handwheel is turned until it touches
the microswitch (3). Only at this point can the
machine be put into operation.
 The current belt tension is displayed on the
blade tension gauge (2).
NOTICE: The position of this microswitch is
factory set. For this reason, when replacing the
saw band, it is necessary to use only saw bands
that comply with the technical data (see 4.3).
OPERATION
37
BS320TOP