Height Adjustment Of The Product; Fix Variant; Variants Lift 1 And Lift 2; Up/Down Control Panels - Steelcase Migration SE Tisch & Bench Bedienungsanleitung

_______________________________________________________________
5.2 Height adjustment of the
product
The height of the Migration SE Desk & Bench
product is adjusted via an electrically powered,
variable lifting mechanism with the variants Lift 1 and
Lift 2. A direct height adjustment feature is not
available for the Fix variant (only for the desk).
Fix
5.2.1 variant
The desk has a fixed height of 740 mm. With the
exception of height adjustment for uneven floors, the
desktop height cannot be adjusted.
Lift 1
5.2.2 Variants
The Migration SE Desk & Bench product can be
variably adjusted by means of an electric motor to a
height between 720 mm and 1200 mm (variant Lift
1) or between 650 mm and 1250 mm (variant Lift 2).
Before first use, ensure that:
The product has been assembled correctly
■
The controller is connected to the motor via
■
cable
The control panel is connected to the controller
■
All safety-relevant information has been followed
■
For the power connection
 Insert the mains plug into a power point
supplying 220/230 V.
Prior to putting the desk in service, it is
necessary to perform a manual reset.
The relevant instructions can be found in
the description of the corresponding
control panel.

5.2.3 Up/Down control panels

The control panel is located on the left- or right-hand
side, on the underside of the desktop.
12
Lift 2
and
Operating and adjusting
Fig. 5-2: Up/Down control panel version
ATTENTION
Risk of damage to control panel!
 Do not lean on the control
panel.
Do not place any objects on the

control panel.
Do not pour liquids over the

control panel.
Height adjustment – Up/Down control panel
 Press the appropriate "Up or Down" button
to reach the desired desktop height.
The desktop moves up or down.
=
Release the "Up or Down" button.

The desktop stops at the desired point.
=
Manual reset of desktop
Wait for 5 seconds if the desk has just been

connected to the mains.
 Press and hold the "Down" button until the
lower end position is reached.
 Continue to hold the "Down" button for at
least 3 seconds.
The resetting and initialisation process is
=
starting.
 After conclusion of the resetting and
initialisation process, press the "Up" button.
The desired height is reached.
=
153310