Your Machine At A Glance; Fitting - Lux Tools E-WSS-21 Bedienungsanleitung

• Symbols appearing on your product may not be
removed or covered. Information on the product
that are no longer legible must be replaced imme-
diately.
Read and observe the operating instructions
before commissioning.
The protective insulation creates protection
from contact with electric parts under power
by providing additional insulation around the
necessary operational basic insulation. The
protective insulation corresponds to protec-
tion class II.
Personal safety equipment
Wear goggles when working with the device.
Wear ear defenders when working with the
device.
When working with tools that cause consider-
able dust, wear a dust protection mask.
Do not wear protective gloves when working
with the device.
Wear tight fitting clothes when working with
the device.
If you have long hair, cover or wear a hair net.

Your machine at a glance

Note: The actual appearance of your prod-
uct may differ from the illustrations.
► P. 3, item 1
1. On-Off switch
2. Additional hand grip
3. Protective hood for grinding
Dimensions D
d
115 mm
125 mm
D
b
115 mm
D
125 mm
Fitting the abrading disc
DANGER! Risk of injury! Never use dam-
aged abrading discs. Always check the
abrading disc for cracks or other damage
before fitting it.
Use only abrading discs whose permitted
rotational speed is at least as high as the
idling speed of the appliance (► Technical
data – p. 35).
b d
6 mm 22,2 mm
6 mm 22,2 mm
— —
— —
4. Abrading disc
5. Tensioning lever for protective hood
6. Locking button for spindle
What is included
• Angle grinder
• Protective hood for grinding
• Additional hand grip
• Face pin wrench for fitting abrading disc
• Instructions for use

Fitting

Fit the additional hand grip
► P. 3, item 2
The additional handle can be attached on the left [1]
or on the right [2] of the product.
– Screw the additional hand grip firmly into the
threaded hole on the appliance.
Permissible grinding tools
• The permissible maximum rpm or cutting speed of
the abrasive bodies used must comply with the
details in the table below.
• Therefore please observe the permissible rpm or
peripheral speed on the label of the abrasive
body.
• Always use the intermediate layers enclosed with
the abrasive bodies: they are positioned between
the abrasive body and the clamping flange and
must be at least the same size as the contact sur-
faces of the flanges.
• When using abrasive bodies with threaded
inserts, it must be ensured that the end of the
spindle never touches the perforated plate of the
grinding tool (spindle length: ► Technical data –
p. 35).
• Abrasive bodies with threaded insert must be able
to be screwed onto the grinding spindle far
enough that they firmly fit the grinding spindle
flange at the end of the grinding spindle thread.
Max. rpm
-1
13300 min
-1
12200 min
-1
13300 min
-1
12200 min
WARNING! Risk of injury! The permitted
diameter for the abrading disc must always
be complied with (► Technical data –
p. 35).
CAUTION! Risk of injury! Use only abrad-
ing discs which are permitted for the mate-
rial being worked with.
► P. 4, item 4
– Press the spindle locking button on the top of the
tool and keep it pressed.
GB
max. cutting speed
80 m/s
80 m/s
80 m/s
80 m/s
33