Wall Mounting; Before You Start - HIKVISION EXIR Schnellstartanleitung

Network Bullet Camera·Quick Start Guide
3 Installation

Before you start:

●
Make sure the device in the package is in good condition and all the
assembly parts are included.
●
The standard power supply is 100 VAC to 240 VAC, PoE (802.3 at, 42.5 to 57
VDC), 0.2 to 0.3 A, please make sure your power supply matches with your
camera.
●
Make sure all the related equipment is power-off during the installation.
●
Check the specification of the products for the installation environment.
●
Make sure that the wall is strong enough to withstand four times the
weight of the camera and the bracket.
For the camera that supports IR, you are required to pay attention to the
following precautions to prevent IR reflection:
●
Make sure that there is no reflective surface too close to the camera lens.
The IR light from the camera may reflect back into the lens causing
reflection.

3.1 Wall Mounting

Before you start:
There is no wall mounting bracket included in the package. You have to prepare a
wall mounting bracket if you choose this mounting type. The shown bracket
below is only for demonstration.
Steps:
1.
Fix the wall mounting bracket to the desired place on wall with four expansion
screws.
Figure 1-6
2.
Unscrew and remove the pedestal from the bracket.
Expansion Screws
Install the Wall Mounting Bracket
12