Table Of Configuration Step Codes - Telecom Behnke 10-Serie Anleitung

Instructions for Series 10
GB
Configuration and Set-up

4.2. Table of configuration step codes

Code Parameter
Reset and return to default settings:
00 * * * *
* * * *
Performing a reset will format the entire memory and all para-
meters will return to their default settings. Performing a reset
will take several seconds. During a reset, the device will
produce a high-pitched tone.
Change the security code: Default setting: 0 0 0 0
01 new security code [beep] new security code
The security code is a four-digit code. Please enter the new
security code twice. The default security code is: 0 0 0 0.
Please note: To prevent unauthorised changes in your configu-
ration, we strongly advise you to change your device's security
code.
Answering a call: Default setting: 1
03 0 = manually by pressing a button
1 = automatically
Input delay for direct call buttons: Default setting: 0
04 0 = none
1 = 1 second
9 = 9 seconds
During this configuration step, it will take a couple of seconds
before the device will confirm a correct entry. Choosing this
option will result in a direct call button to be pressed for at least
the amount of time specified before connection of a direct call.
Connection interval:
05 0 = unlimited (i.e. limited to a connection time of approx. 8
hours)
1 = limited to 1 minute
9 = limited to 9 minute
After the connection interval has elapsed, the connection will
be terminated automatically.
Volume Default setting: 7
06 0 = very low volume
9 = very loud volume
Use this configuration step to adjust the volume in full duplex
mode (standard mode).
44
All manuals and user guides at all-guides.com
Default setting: 3
Confirmation
#
#
#
#
#
#
#
#
#
#
#
#
www.behnke-online.com