Waeco MagicWatch MWE650 Montage- Und Bedienungsanleitung Seite 37

MWE-650-4DSM.book Seite 37 Dienstag, 16. Mai 2006 4:42 16
MagicWatch MWE650
The installation location should be as flat as possible so that the cover ring
of the sensor is on the bumper.
The sensor is preset to have a vertical installation angle of
approximately +5°. This means that the cover ring is thicker at the bot-
tom.
Note that the sensors must be aligned in a particular direction. The top of
the cover ring is thinner and gets thicker towards the bottom (see fig. 12,
page 6).
Fit the sensors at regular intervals along the total width of the vehicle in
order to guarantee the optimum monitoring.
The installation procedure is as follows:
➤ Choose an installation location on the bumper which is as perpendicular
to the road surface as possible (see fig. 12, page 6).
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤ For each sensor, drill a hole with a diameter of 24 mm in the bumper.
➤ Insert the sensor in the drill hole.
➤ Guide the cables of the sensors through the corresponding hole.
➤ Insert each sensor into the corresponding drill hole until it latches into
place.
6.3 Laying the sensor extension cables
When laying cables, ensure that:
They are not kinked or twisted
They do not rub on edges
They are not laid in sharp edged ducts without protection (see fig. 3,
page 4).
The plugs must be connected with the correct polarity. A blocking pin pre-
vents reverse polarity (see fig. 13 A, page 6).
Installing MagicWatch
37