Wolf Garten GT-S 800 Originalbetriebsanleitung Seite 28

GT-S 800/1000
GT-S 1000
MACHINE COMPONENTS
1
F . 4
IG
The package contains the following:
1. Motor unit with half length rod
2. Rod extension with reducer head
3. Wire head guard plate
4. Aluminium flange
5. Plastic bell housing
6. Wire head
7. Harness latch
8. Screw bag
9. Guard extension for wire head
10. Cutting unit guard
11. Supporting harness
12. Front handle with guard
13. Front handle fixing plate
14. Cutting blade
15. Cutting blade locking counter flange
16. Cutting blade locknut
17. Earmuffs
18. Goggles
6. A
SSEMBLY INSTRUCTIONS
M
OUNTING THE GRIP
1
F . 5
IG
„
Position the front handle with guard
(F) onto the tube (A), with the lever
facing left (seen from the user's
position).
„
Insert the M5 nuts (B) in their
housing on the front handle fixing
plate (C).
„
Connect the front handle (F) to the
safety guard, to the front handle
fixing plate (C).
„
Fit the washers (D) and push in the
M5x30 screws (E).
„
Slide the grip along the rod until it
reaches a comfortable height (see
fig. 7).
„
Tighten the screws with the
supplied wrench.
28
F
ITTING THE HARNESS LATCH
1
F . 6
IG
„
Position the harness latch (A) onto
the tube (D) between the motor and
the handle.
„
Insert the M5x10 screws (B) and their
nuts (C).
„
Slide the latch towards the rod until it
reaches a suitable position, to suit
the user's height (see fig 7).
„
Tighten the screws with the key supplied.
M
OUNTING THE GUARD
1
F . 10
IG
„
Fit the two square M5 nuts (F) into
the relative holes in the lower part of
the guard (A).
„
Position the connector (B) on the
gear box (C) so that the screw of the
gear box lies in the central hole.
„
Attach the guard to the connector.
„
Insert the M5x20 screws (D).
„
Tighten the screws with the supplied
wrench.
ATTENTION: Never work without the guard!
M /
OUNTING DISMOUNTING THE CUTTING
(
ASSEMBLY FOR DISMOUNTABLE MODELS
1
F . 11-12
IG
„
Align the release button (A) with the
hole in the guide (B) to simplify
installation.
„
Hold the dismountable cutting
assembly firmly and push it into the
clamp until the release button (A)
enters the hole in the clamp (C).
„
Tighten the knob (D) (right-hand
thread). Make sure it is perfectly tight
before using the unit.
To dismount the cutting assembly,
proceed in reverse order:
„
Loosen the knob (D) (right-hand thread).
„
Press down on the release button (A).
„
Slide the cutting assembly off the clamp.
)