Assembly; Adjusting The Carrying Straps; Fuelling; Fuel Information - Solo 434 Gebrauchsanweisung Und Originalbetriebsanleitung

5. Assembly

The high pressure sprayer may only be used after
complete assembly and after the carrying straps
have been adjusted correctly!
To facilitate packing and transport, the spray wand
(17) and trigger handle (15) are not attached to the
pressure hose (14)
Fasten the pressure hose (14) to the trigger
handle (15) by tightening the hex. Nut (20)

6. Adjusting the carrying straps

Use the sliding clips, adjust the shoulder straps to
the right length.
a) Pull the loose ends of the carrying straps to
tighten them.
b) Lift up the two sliding clips again to release the
straps.
When adjusting the straps, ensure that the back
panel fits snugly and securely against the back of
the person wearing the backpack.
Assembly ; Adjusting the carrying straps ; Fuelling

7. Fuelling

7.1 Fuel information

A high performance two-stroke engine
operated with a petrol:oil mixture (petrol + oil
= fuel mixture) or with a special fuel mixture for
two-stroke engines available from specialists
powers this machine.
We recommend the proprietary "Aspen 2-takt"
special fuel mixture. Please observe the special
fuel manufacturer's instructions.
Information on individual mixing of the fuel mixture
Normal or super unleaded petrol can be used for
individual mixing purposes (minimum octane
number 92 RON).
When using a particularly high quality proprietary
2-stroke engine oil such as the "SOLO Profi 2T-
Motoröl" which we supply, we recommend an
oil:petrol mixing ratio of 1:50 (2%).
When using other brands of 2-stroke oil we
recommend a mixing ratio of 1:25 (4%).
Only use proprietary 2-stroke engine oil!
Never store fuel mixture longer than 3 - 4 weeks.
Fuel mixture table
Petrol in
litres
SOLO
2T engine oil
2% (50 : 1)
1 0.020
5 0.100
10 0.200
Unsuitable petrol or deviations in the mixing ratio
may lead to serious engine damage!
Avoid direct skin contact with petrol and
avoid inhaling petrol fumes - health hazard!
7.2 Fuelling
While fuelling always follow all safety instructions
and take all safety precautions.
Handle fuel only with the engine turned off.
Carefully clean the area around the filler inlet.
Place the machine with the fuel inlet pointing
upwards. Unscrew the tank lid and fill the fuel
mixture up to the lower edge of the filler neck. Use
a funnel with filter to prevent tank contamination.
After filling the tank replace the tank lid and tighten
firmly.
Oil in litres
Other
two-stroke oils
4% (25 : 1)
0.040
0.200
0.400
ENGLISH 9