few seconds, then the duration of the se-
lected programme is displayed again.
• Alarm codes
In the event of operating problems, some
alarm codes can be displayed, for exam-
ple
(see paragraph «What to do
if...»).
• Incorrect option selection
If an option which is not compatible with
the set wash programme is selected, the
message Err is displayed at the bottom
of the display for a few seconds and the
integrated red light of button 8 start flash-
ing.
• End of programme
When the programme has finished three
flashing zeros are displayed, the pilot light
9 and the pilot light of button 8 go out
and the door can be opened.
7.2: Washing programme phase icons
• Wash
• Rinses
• Drain
• Spin
By selecting the wash programme, the
washing programme phase icons corre-
PERSONALISATION
ACOUSTIC SIGNALS
The machine is provided with an acoustic
device, which sounds in the following ca-
ses:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultane-
ously for about 6 seconds, the acoustic
signal is deactivated (except if there is a
fault). By pressing these 2 buttons again,
the acoustic signal is reactivated.
CHILD SAFETY LOCK
This device permits you to leave the appli-
ance unattended and not to worry that chil-
FIRST USE
• Ensure that the electrical and water
connections comply with the installa-
tion instructions.
• Remove the polystyrene block and
any material from the drum.
All manuals and user guides at all-guides.com
sponding to the various phases making up
the programme are shown in the bottom
part of the display. After having pressed
button 8 only the icon of the running phase
stays on.
7.3: Heating phase
During the washing cycle the display shows
a temperature icon indicating that the appli-
ance has started the heating phase of the
water in the tub.
7.4: Soil degree icons
• Intensive
• Normal
• Daily
• Light
• Quick
• Super Quick
• Refresh
• Super Refresh
When selecting a programme on the dis-
play appears an icon indicating the degree
of soiling automatically proposed by the
machine.
7.5: Child safety lock
ty Lock» paragraph).
dren might be injured by or cause damage
to the appliance. This function remains ena-
bled also when the washing machine is not
working.
There are two different ways to set this op-
tion:
1. Before pressing button 8: it will be im-
2. After pressing button 8: it will be im-
To enable or disable this option press si-
multaneously for about 6 seconds buttons
5 and 6 until on the display, the icon
pears or disappears.
possible to start the machine.
possible to change any other pro-
gramme or option.
• Before the first wash, run a cotton
cycle at the highest temperature
without any laundry in the machine,
to remove any manufacturing residue
from the drum and tub. Pour 1/2 a
measure of detergent into the main
electrolux 7
(see «Child Safe-
ap-