Philips Aqua Plus 8000-Serie Bedienungsanleitung Seite 13

Problem
The appliance is not
charging.
The mini Turbo brush does
not function properly.
When I use my vacuum
cleaner I sometimes feel
static electricity shocks.
Using the water tank
Problem
The water flow from the
water tank is reduced.
Possible cause
The magnetic connector is
not connected properly to
the charging disk or the
adapter is not inserted into
the wall socket properly.
You have not connected the
adapter supplied.
XB8347, XB8349 only: The
Vacuum & Wipe nozzle is
attached while charging the
appliance on the wall-
mounted charging station.
The roller brush is blocked.
The roller brush is blocked by
fabric or surfaces during
cleaning.
The roller brush is not
properly inserted into the
mini Turbo brush.
Your vacuum cleaner builds
up static electricity. The lower
the air humidity, the more
static electricity the
appliance builds up.
You vacuumed up dust and
dirt. This also causes static
electricity.
Possible cause
The wetting strip is blocked
by dirt.
Solution
Make sure that the magnetic connector
is connected properly to the charging
disk and that the adapter is inserted into
the wall socket properly.
Make sure that you use the adapter
supplied.
Make sure that you attach the 360°
suction nozzle when you charge the
appliance on the charging station.
If you have checked the above and the
appliance still does not charge, take it to
a Philips service center or contact the
Consumer Care Center.
Remove hairs from the brush with a pair
of scissors (see user manual).
Keep the mini Turbo brush aligned with
the surface and do not push the Turbo
brush into soft surfaces.
Make sure that roller brush and the mini
Turbo brush are properly connected and
that there is no gap between the parts
(see user manual).
Discharge the appliance by frequently
holding the tube against other metal
objects in the room (for example the
legs of a table or chair, etc.). You can
also raise the air humidity level in the
room.
Empty the dust container and clean the
filter (Fig. 9) according to the instructions
in the user manual.
Solution
Remove the wetting strip and clean it.
English
13