Symbols; Warnings; Installation - Cebora WIN TIG AC-DC 270T Kurzanleitung Für Installation Und Betrieb

1

SYMBOLS

DANGER
WARNING
CAUTION
NOTICE!
INSTRUCTION
The colour of the box indicates the category into which the operation falls: DANGER, WARNING, CAUTION, NOTICE or INSTRUCTION.
2

WARNINGS

Before handling, unpacking, installing and using the welding power source, it is obligatory to read the WARNINGS set out in manual
3301151
3

INSTALLATION

Connecting high power devices to the mains could have negative repercussions on mains power quality. Line impedance values lower than
the Zmax value indicated in the table may be required for compliance with IEC 61000-3-12 and IEC 61000-3-11. It is the responsibility of the
installer or user to ensure that the device is connected to a line of correct impedance. It is advisable to consult your local electricity supplier.
Make sure that the mains voltage matches the voltage indicated on the specifications plate of the welding machine. Connect a plug of adequate
capacity for the current consumption I1 indicated on the data plate. Make sure that the yellow/green conductor of the power cable is connected
to the plug's earth contact.
If mains power extensions are used, the cable supply cross-section must be appropriately sized. Do not use extensions longer than 30 m. (nota
per PER VIRGINIA : DA ISTRUZIONE ESTESA 3301062)
The machine must be installed by professional personnel. All connections must be carried out according to current regulations, and in full
observance of safety laws (CEI 26-36 and IEC/EN 60974-9).
The power source is turned on and off using switch G.
Gas cylinders contain gas under pressure and can explode if damaged. Because
the gas cylinders are an integral part of the welding equipment, they must be handled with extreme caution. (See General Warnings manual
3301151)
3301229
Indicates a situation of imminent danger that could cause severe injury to people
Indicates a situation of potential danger that could cause severe injury to people
Indicates a situation of potential danger that could cause slight injury to people and material damage to
equipment if not respected.
Provides important information to the user that could lead to damage to equipment if not observed.
Procedure to be followed to achieve optimal use of the equipment.
DANGER
WARNING
WARNING
WARNING
13/21