Additional Work With Conveyor Option - HEIDELBERG Suprasetter A52 Installationsanleitung

Installation

Additional Work with Conveyor Option

Fig. 30 Conveyor retainer
Fig. 31 Conveyor
Fig. 32 Hooking in the conveyor
Fig. 33 Buffers on the lower side of the conveyor
48
The conveyor comes separately packed.
Remove the top rear cover (Fig. 30/1) and the
bezel (Fig. 30/2).
Screw two combination screws at the top left and
right (Fig. 31/1) loosely into the conveyor.
Hook the conveyor (Fig. 32/1) into the holders with
the two combination screws, align them centrally,
and fasten it with the six combination screws
M4x10.
Make absolutely sure: The two buffers (Fig. 33/
1) on the conveyor must always rest on the module
(if any) below it or the conveyor must be propped
up with a suitable support. If this is not done, the
entire weight bears down on the motor shaft,
causing the motor shaft (Fig. 34/1) to break.
Point this out to your customers as well!