Operation - Sanitas 614.51 Gebrauchsanweisung

3. Initial use
Setup
Remove the unit from the packaging. Remove all packaging material before using the appliance. Before use,
check whether the infrared lamp is properly screwed in. Place the device on flat surfaces. The appliance has an
adjustable lampshade. Set the angle of the fluorescent screen in accordance with your individual requirements.
Mains connection
Connect the unit only to the mains voltage listed on the type plate.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.

4. Operation

1 Switching on the lamp
 Push the plug completely into the mains socket.
2 Enjoying the light
While using the lamp on the face, always keep the eyes closed in order to avoid injury to the eyes (do not
look directly at the infrared light).
The recommended duration of treatment is maximum 12 minutes. We recommend selecting a shorter
radiation period to start with. However, the skin of some people may show an over-sensitive (e.g. with
extreme redness, blistering, itching, heavy sweating) or allergic reaction to heat radiation, even when the
lamp is used correctly.
3 Important instructions
The distance between the infrared lamp and the radiated part of the body should not be less than the
following:
SIL 06: at least 24 in (60 cm)
SIL 16: at least 32 in (80 cm)
Basically,
examine the radiated section of the body regularly. Discontinue radiation immediately if any signs of an
over-sensitive or allergic reaction appear and consult a physician.
4 Switching off the lamp
 Pull the mains plug from the socket.
CAUTION!
The lamp is hot after being used. Let the lamp cool off first long enough before you put it
away and/or pack it up!
Please note that the mains cable must not be wound round the infrared lamp either for storage or when
in use.
5. Changing the infrared lamp
The device must be switched off and allowed to cool and the mains plug pulled out before cleaning and chan-
ging the infrared heat lamp.
Please note that only infrared lamps of the original type may be used as replacements.
Appliance Replacement infrared lamp (type)
:
SIL 06 Infrared R95 (100 W)
SIL 16 Infrared PAR 38 (150 W)
Warning
• Do not touch the infrared lamp or unscrew it when it is connected to the mains.
• Unplug the device, to avoid the risk of electrocution.
• In the interest of environmental protection, do not dispose of the device in haousehold waste.
Specifications
: :
230V ~ 50 Hz
230V ~ 50 Hz
9
Item number:
614.51
616.51