STEINEL XLED CAM 1 SC Installationsanleitung Seite 18

• Using a voltage tester, check to make
sure the light is disconnected from
the power supply.
• Make sure power supply remains
interrupted.
Risk of damage to property!
Mixing up connection leads may pro­
duce a short circuit.
• Identify connection leads.
• Re­connect connection leads.
Preparing for installation
• Check all components for dam­
age. Do not use the product if it is
damaged.
• Select an appropriate site to install
the product.
– Take reach into consideration.
(Fig. 4.1)
– Take reach and motion detection
into consideration. (Fig. 4.2/4.3)
– Vibration­free.
– No obstacles in detection zone.
– Not in explosive atmospheres.
– Not on normally flammable
surfaces.
– Do not look into the LED light from
a short distance (<20 cm).
– Stable connection to the Wi­Fi
router (2.4 GHz band).
Mounting procedure
• Check to make sure the power sup­
ply is switched OFF. (Fig. 3.4)
• Unscrew retaining screw. (Fig. 4.4)
• Disconnect sensor­switched flood­
light from the wall mount by pressing
the clip. (Fig. 4.4)
• Mark drill holes. (Fig. 4.5)
• Drill holes (Ø 6 mm) and fit wall plugs.
(Fig. 4.6)
• Firmly screw wall mount into place.
(Fig. 4.7)
• Connect mains power supply lead
according to terminal labelling.
(Fig. 4.8/3.4)
• Aim sensor­switched floodlight
and fix in place with grub screws.
(Fig. 4.9)
• Fit sensor­switched floodlight on the
wall mount. (Fig. 4.10)
• Tighten retaining screw. (Fig. 4.10)
• Switch ON power supply. (Fig. 4.10)
5. Configuration
Steinel CAM app
Android
iOS
• Download Steinel CAM app.
System requirements
– Same 2.4 GHz Wi­Fi network for
sensor­switched floodlight and
smartphone or tablet.
– The Wi­Fi router enables the devices
to communicate with each other.
– While configuring, no connection to
guest access or repeater.
Configuring unit
Power supply connected:
– The unit boots.
– Status LED lights up red.
18