MTD products Cub Cadet XT3QR95 Originalbetriebsanleitung Seite 23

Servicing
Attention!
Fuel may run into the combustion chamber.
ÂDamage to engine
¾ The mower must not be tilted to an angle greater
than 30°.
Bring the cutter deck to the top position.
Î
Clean the cutting chamber with a scrubbing brush,
Î
hand brush or a cloth.
Cutting mechanism with cleaning nozzle
(optional) W
Cleaning
Park the device on a clean and firm foundation.
Î
Switch the parking brake on.
Î
Use a commercially available quick-release cou-
Î
pling to attach a water hose.
Start the engine.
Î
Lower the cutter deck and switch it on.
Î
Allow the engine and cutter deck to run for a few
Î
minutes.
Switch the engine and cutter deck off.
Î
Note
If available, repeat the steps for the second
cleaning nozzle.
Drying
Bring the cutter deck to the top position.
Î
Start the engine and switch the cutter deck on.
Î
To dry the cutter deck, allow the engine and cutter
Î
deck to run for a few minutes.
Switch the engine and cutter deck off.
Î
Cleaning the grass catcher
Attention!
¾ Note the separate operating instructions for the
grass catcher.
Detach the grass catcher and empty it.
Î
Clean the grass catcher with a powerful water jet
Î
(e.g. with a garden hose).
Allow the grass catcher to dry thoroughly before
Î
next use.
Starting the device
Observe the servicing instructions in the engine
Î
manual.
At the end of the season, have the mower in-
Î
spected and serviced by a service centre.
Note
After changing the oil, take the waste oil
to a waste oil collecting point or to a waste
disposal company.
Note
Return used batteries to your dealer or a dis-
posal company. Remove the battery in the
device before the device is scrapped.
Using jump leads
Risk of explosion / short-circuit
¾ Never bypass a defective or frozen
battery with jump leads.
¾ Ensure that the units and the jump lead
clips do not touch each other and that
the ignitions are switched off.
Attach the red jump lead to the positive terminal
Î
(+) of the discharged battery and to the positive
terminal (+) of the donor battery.
Connect the black jump lead first to the negative
Î
terminal (–) of the donor battery.
Attach the other terminal on the frame near to the
Î
engine block of the lawn tractor as far away from
the battery as possible.
Note
If the donor battery is installed in a vehicle,
this vehicle must not be started during the
jump starting process.
Start the lawn tractor.
Î
Switch the parking brake on.
Î
Disconnect the jump leads in reverse sequence.
Î
Tyre pressure
Increased tyre pressure
ÂRisk of accident and damage to the
device
¾ Never exceed the permitted tyre
pressure (see tyre wall).
Check the tyre pressure and correct it where
Î
necessary.
Front 0.9 bar
Rear 0.7 bar
Note
Excess tyre pressure reduces the service
life of the tyres. Check tyre pressure prior to
each journey.
DANGER!
WARNING!
EN
23