Assembly - MTD products Cub Cadet XT3QR95 Originalbetriebsanleitung

EN
Directional references
Directional references on the device (e.g. left, right,
etc.) always refer to when facing forwards.

Assembly

Note
In order to be able to move the tractor, the
gear release lever must be in the appropri-
ate position. Refer to the section "Operation
– Pushing the mower".
Attaching the seat B
Remove the screws and nuts on the seat sup-
Î
port 1 .
Fix the seat support to the mounting bracket 2
Î
using the previously removed screws and nuts.
Press the adjustment lever or open the adjustment
Î
screw (depending on the model) 3 .
Push the seat into a position in which you have
Î
good access to the seat connector 4 .
Attach the connection cable to the seat con-
Î
nector 5 .
Retighten the seat adjustment screw (depending
Î
on the model).
Note
The seat is equipped with a seat-occupation
sensor, which belongs to the safety locking
system. The device can thus only be oper-
ated correctly when the connection cable is
correctly inserted into the seat connector.
Attaching the upper dashboard covering
(model-dependent) Ca
Insert the tabs (A) of the dashboard covering [B]
Î
into the openings of the dashboard support [C] 1 .
Press them forwards until the stop 2 .
Î
Check the covering fits firmly.
Î
Attaching the engine hood covering
(model-dependent) C b
Place the engine hood covering with the re-
Î
cesses [A] on the retaining brackets [B] on the
engine hood 1 .
Press the covering backwards until the stop 2 .
Î
Press both clips [C] slightly upwards to lock the
Î
cover 3 .
Check the covering fits firmly.
Î
14
Attaching the steering wheel D
Remove the cover cap [1] (design-dependent) on
Î
the steering wheel.
Place the spacer [6], the spring [5] and the
Î
washer [4] onto the steering shaft [7].
Place the steering wheel on the steering shaft.
Î
Fasten the steering wheel using the washer [3]
Î
and the screw [2] (tightening torque: 25-28 Nm).
Note
Put on the washer [3] with the bulge facing
upwards.
Put on the cover cap [1].
Î
Note
After disassembling the steering wheel
screw, this must be replaced with a new
original screw and screw retention.
Attaching the front bumper
(model-dependent) E
Remove the four screws from the front bumper.
Î
Fasten the front bumper to the tractor frame (inner
Î
side) using the previously removed four screws.
Putting the battery into operation
Risk of fire, explosion and corrosion
caused by battery acid and gases emitted
by battery acid
¾ Battery acid is corrosive. Immediately
clean all parts of the device splashed by
battery acid.
¾ Do not smoke; keep burning and hot
objects away.
¾ Charge batteries in a well ventilated and
dry room only.
¾ There is a risk of a possible short circuit
when working with the battery. Do not
place any tools or metal objects on the
battery.
Assembly
DANGER!