Replacing The Interior Light Bulb; Defects Finding Guide - Beko GT29540CHN Gebrauchsanweisung

EN
After the melting of the ice and the run-off of
the water please wipe with a cloth or with a
sponge, then dry well. Put the obstruction plug
back in its place. (Item. 6)
For a fast thaw please leave the door open.
Do not use sharp metal objects to remove
the ice.
Do not use hairdryers or other electric
heating appliances for defrosting.
Inside cleaning
Before starting the cleaning, unplug the
appliance from the mains.
 It is advisable to clean the appliance when
you defrost it.
 Wash the inside with lukewarm water where
you add some neutral detergent. Do not use
soap, detergent, gasoline or acetone which
can leave a strong odour.
 Wipe with a wet sponge and dry with a soft
cloth.
During this operation, avoid the excess of
water, in order to prevent its entrance into the
thermal insulation of the appliance, which
would cause unpleasant odours.
Do not forget to clean also the door gasket
especially the bellow ribs, by means of a
clean cloth.
Outside cleaning
 Clean the outside of the freezer by means
of a sponge soaked in soapy warm water,
wipe with a soft cloth and dry.
 The cleaning of the outside part of the
refrigerating circuit (motorcompressor,
condenser, connection tubes) will be done
with a soft brush or with the vacuum-cleaner.
During this operation, please take care not to
distort the tubes or detach the cables.
Do not use scouring or abrasive materials !
 After having finished the cleaning, replace
the accessories at their places and plug in the
appliance.

Replacing the interior light bulb

If the lamp burns out, disconnect the
appliance from the mains. Take out the lamp
trim. Make sure the lamp is screwed correctly.
Plug in the appliance again. If the lamp still
does not go on, replace it with another one
model E14-15W. Mount back the lamp trim in
its place.
The lamp(s) used in this appliance is not
suitable for household room illumination. The
intended purpose of this lamp is to assist the
user to place foodstuffs in the
refrigerator/freezer in a safe and comfortable
way.
The lamps used in this appliance have to
withstand extreme physical conditions such as
temperatures below -20 °C.

Defects finding guide

T h e a p p l i a n c e d o e s n o t w o r k .

There is a power failure.
 The plug of the supply cord is not inserted
well into the socket.

The fuse is blown.
The thermostat is in „OFF" position.

T h e t e m p e r a t u r e s a r e n o t l o w
e n o u g h ( r e d L E D o n ) .

The food prevents the door closing.

The appliance was not placed correctly.

The appliance is placed too close to a heat
source.

The thermostat knob is not in the correct
position.
E x c e s s i ve i c e b u i l d - u p
The door was not closed properly.

T h e i n s i d e l i g h t i n g d o e s n o t w o r k

The lamp is blown. Unplug the appliance
from the mains, take out the lamp and
replace it with a new one.
T h e f o l l o w i n g a r e n o t d e f e c t s
 Possible noddings and cracks coming
from the product: circulation of the
refrigerant in the system.
6
Instruction for use