Replacing The Interior Light Bulb; Defects Finding Guide - Beko HSA 24540 Bedienungsanleitung

EN
Inside cleaning
Before starting the cleaning, unplug the
appliance from the mains.
 It is advisable to clean the appliance when
you defrost it.
 Wash the inside with lukewarm water
where you add some neutral detergent. Do
not use soap, detergent, gasoline or acetone
which can leave a strong odour.
 Wipe with a wet sponge and dry with a soft
cloth.
During this operation, avoid the excess of
water, in order to prevent its entrance into the
thermal insulation of the appliance, which
would cause unpleasant odours.
Do not forget to clean also the door gasket
especially the bellow ribs, by means of a
clean cloth.
Outside cleaning
 Clean the outside of the freezer by means
of a sponge soaked in soapy warm water,
wipe with a soft cloth and dry.
 The cleaning of the outside part of the
refrigerating circuit (motorcompressor,
condenser, connection tubes) will be done
with a soft brush or with the vacuum-cleaner.
During this operation, please take care not to
distort the tubes or detach the cables.
Do not use scouring or abrasive materials !
 After having finished the cleaning, replace
the accessories at their places and plug in the
appliance.

Replacing the interior light bulb

If the lamp burns out, disconnect the
appliance from the mains. Take out the
lamp trim. Make sure the lamp is
screwed correctly. Plug in the appliance
again. If the lamp still does not go on,
replace it with another one model E14 -
15W. Mount back the lamp trim in its
place.

Defects finding guide

The appliance does not work.
 There is a power failure.

The plug of the supply cord is not inserted
well into the socket.

The fuse is blown.
The thermostat is in „OFF" position.

The temperatures are not low enough(red
LED on).

The food prevents the door closing.
 The appliance was not placed correctly.

The appliance is placed too close to a heat
source.

The thermostat knob is not in the correct
position.
Excessive ice build-up
 The door was not closed properly.
The inside lighting does not work

The lamp is blown. Unplug the appliance
from the mains, take out the lamp and
replace it with a new one.
The following are not defects
 Possible noddings and cracks coming
from the product: circulation of the
refrigerant in the system.
6
Instruction for use