DoorBird D11 Serie Installationsanleitung Seite 8

Only for D1101V & D1102V
We offer additional wall-mounting kits for D1101V
and D1102V Surface-Mount with a wedge corner
wall-mount adapter (7.5° vertical down or up) and
alternatively an angle corner wall-mount adapter (45°
horizontal, mounts left or right).
A8001 Wedge corner
wall-mount adapter
(7.5°, mounts vertical
down or up), sold
separately
4
ASSEMBLING THE MOUNTING HOUSING
The product is available as a surface-mounted and flush-mounted version. In the flush-mounted version, the front
panel is slightly larger to better cover the hole in the wall and the mounting housing (backbox) is made entirely
of metal instead of plastic.
If you use the flush-mounted housing, lever up the
wall accordingly.
If the wall of the house is not made of wood, you
should drill dowel holes 5 mm (0.19 in) in diameter in the wall according to the drilling template and then place
the dowels provided into the boreholes.
If you must drill holes in a wall, insert screws into a wall or lever up a wall, ensure that no cables or mains
(gas, water, etc.) are to be found in the wall.
8
A8002 Angle corner
wall-mount adapter
(45° horizontal, mounts
left or right), sold
separately
When choosing the assembly location, consider
the lighting conditions. Avoid direct sunlight, direct
backlight and reflective surfaces.
Do not expose the device to direct sunlight.
N OTI CE
The housing temperature can exceed the
maximum allowed temperature limit.
This can result in damage of electric and
mechanic components of the device and
injuries especially when touching exterior
parts of the device. White and bright silver-
colored front plates absorb less sunlight than
dark ones.
An image sensor must not be exposed to
N OTI CE
direct sunlight for an extended period of
time. Direct sunlight will "blind" the camera
and may permanently bleach the small color
filters on the image sensor chip.
Any defects caused by direct sunlight are not
covered by warranty.
If the wall of the house is made of wood, dowels
are not normally required. There are special dowels
for assembling the device on an insulating wall, e.g.
Fischer insulating dowels.