Service; Operational Problems - Troubleshooting - Jotul F8TD Montage- Und Bedienungsanleitung

7.0 Service

Warning! Any unauthorised change to the product is illegal.
Only use original spare parts.
Replacing the baffle plates - burn
plates - inner bottom (fig. 7)
Remove the ash retainer. (A)
•
• Lift the baffle plate forward and to the side and edge it out
of the door. (B)
Remove the burn plates. (C)
•
Lift up the inner bottom and edge it out. (D)
•
For re-installation follow the same procedure in reverse order.
8.0 Reasons for operational
problems - troubleshooting
Poor draught
• Check the length of the chimney so that it covers the
requirements stipulated in national laws and regulations. See
also «2.0 Technical data» and «4.5 Chimney and flue pipe»
for information.
• Ensure that the minimum cross-section of the chimney is in
accordance with «2.0 Technical data»
• Make sure that there is not anything preventing the flue
gasses from escaping: Branches, trees, etc.
The fire extinguishes after a while
• Make sure that the wood is sufficiently dry
• Find out whether there is negative pressure in the house, close
mechanical fans and open a window close to the stove
• Check that the air vent is open.
• Check that the flue outlet is not clogged by soot
Unusual amount of soot accumulates on
the glass
Some soot will always stick to the glass, but the quantity depends
on:
• Humidity of the wood
• Local draught conditions
• Regulating the air vent.
Most of the soot will normally burn off when the air vent is
opened all the way and a fire is burning briskly in the fireplace.
See also «6.1 Cleaning of glass - good advice».
ENGLISH
13