Malfunction Analysis - vidaXL 50762 Bedienungs- Und Sicherheitshinweise

• Check whether heat discharge pipe is damaged.
8.5 Checking after use-season
• Disconnect power supply.
• Clean filter and outer case.
• Remove dust and sundries on the air conditioner.
• Eliminate accumulated water in chassis (refer to the section
of "Drainage way" for details).
• Check whether window bracket is damaged or not. If yes,
please contact dealer.
8.6 Long-time Storage
If you don't use the air conditioner for a long time, please
8.8

Malfunction analysis

Please check below information before contacting a technician. If the problem still exists, please contact the local dealer or a
qualified technician.
Phenomenon
Air conditioner can't
operate
Poor cooling (heating)
Air conditioner can't
receive signal from
remote controller or
remote controller is
not sensible.
No air blowed out
from air conditioner.
Set temperature can't
be adjusted.
28 | 50762
Troubleshooting
Power failure?
Is plug loose?
Whether the air switch is tripped off or
fuse is burnt?
Is there's malfunction for the circuit?
Whether the unit is restarted up after
stopping immediately?
Is the power too low?
Whether the air filter is too dirty?
Whether the set temperature is proper?
Whether door and window are closed?
Whether the unit is interfered seriously
(such as static pressure , unstable
voltage)?
Whether remote controller is within the
receiving range?
Whether it's blocked by obstacles?
Is sensitivity of remote controller low?
Whether there's fluorescence lamp in
the room?
Whether air outlet or air inlet is
blocked?
Under heating mode, whether indoor
temperature reaches set temperature?
Whether heating mode is started up just
now?
Whether evaporator is defrosted?
(observe it by pulling out the filter)
Whether the unit operates under auto
mode?
maintain it by following steps for good performance.
• Make sure there's no accumulated water in chassis and the
heat discharge pipe is disassembled.
• Pull out the plug and wrap the power cord.
• Clean the air conditioner and pack it well to prevent dust.
8.7 Notice for recovery
• Many packing materials are recyclable materials. Please
deal with them through local recycle bin.
• If you want to throw away the air conditioner, please
contact local division or consultant service center for the
correct disposal method.
Solution
Wait after power recovery.
Reinsert the plug.
Ask professional person to replace air switch or fuse.
Ask professional person to replace circuit.
Wait for 3min, and then turn on the unit again.
Wait after voltage is resumed.
Clean the air filter.
Adjust the temperature.
Close door and window.
Please pull out the plug. Insert the plug after about 3min,
and then turn on the unit.
The receiving range of remote controller is 8m. Do not
exceed this range.
Remove the obstacles.
Check the batteries of remote controller. If the power is
low, please replace the batteries.
Move the remote controller close to air conditioner.
Turn off the fluorescence lamp and try it again.
Eliminate the obstacles.
The unit will stop blowing fan after reaching set
temperature.
In order to prevent cold air, air conditioner will delay for a
while to be started up, which is the normal phenomenon.
It's the normal phenomenon. Air conditioner is defrosting.
After defrosting is finished, it will resume operation.
Temperature can't be adjusted under auto mode.