Installing The Activation Master - Simons Voss Technologies BS-9900001 Bedienungsanleitung

Block lock Activation master

6 Installing the activation master

EN
9 Activation master beeps for 2.5 s.
6. Check whether the relay has switched.
7. Press the transponder authorised on the activation
master twice briefly again (0.5 s to 2 s) within
range of the activation master (with external an-
tenna: 1 cm to 3 cm).
9 The relay switches and separates pins 5 and 7
(alarm system would now be deactivated).
Activation master beeps twice (short-long).
9
8. Set jumper B1 to a/b (left).
9. Connect the switching contact and pin 29 to the
burglar alarm system (see
tivation master [
10. Perform the activation test again. The acknow-
ledgement of the activation comes from the burg-
lar alarm system, but is output by the activation
master.
11. Repeat the test several times.
12. Then carry out the installation as described (see
stalling the activation master [
tions of the activation master [
Mount the activation master above the door frame.
Keep a distance of at least one and a half metres from
other SimonsVoss components (see drawing) to
prevent mutual interference.
Align the activation unit so that the fastening screws
are in a horizontal line (see drawing) in order to rule
out interference during normal door operation.
6. Installing the activation master
Connections of the ac-
27] ).
}
25]
}
27]
}
In-
and Connec-
).
25 / 112