Maintenance Intervals; Transport And Storage; Disposal - Stahl 8562/5 Betriebsanleitung

Transport and Storage


The function test must be performed regularly, at least once semiannually, as long as
there are no other regional or customer-specific requirements for additional testing.

Observe the relevant national regulations in the country of use!
The following items must be checked as part of the maintenance schedule:

Check that no cable connections are loose.
 Check the plastic enclosure for cracks or other visible signs of damage.
Check that the permitted temperatures, in accordance with IEC/EN 60079-0, are 

adhered to.

Check the reset function of the switch lever.

Check that the device functions correctly.

Maintenance Intervals

Check explosion-protected components regularly to ensure that its fitting, installation and
operation are in accordance with the regulations.
Refer to the corresponding national regulations (e.g. IEC/EN 60079-14) for the type and
scope of tests. The maintenance intervals must be chosen, such that the occurrence of
deficiences, anticipated in the system, can be avoided.
Note the following when establishing the intervals between checks:
the operating conditions (degree of utilization of the Miniatur Circuit-Breaker, 

maloperation)
 manufacturers' instructions in technical documentation (mechanical and electrical
service life)
 major changes in the whole system (e.g. changes of zone allocation)
Remedial Action
Any defects, which affect the explosion protection, must be remedied immediately:
 Take the device out of operation! (Disconnect it from the supply!)
 Replace the device!
11 Transport and Storage
Transport and Storage are only permitted in the original packing.

12 Disposal

Observe the national standards for refuse disposal.
12
Residual current circuit-breaker with
integral overcurrent protection
8562/5
149915 / 8562606300
2012-08-16·BA00·III·en·06