Endress+Hauser iTEMP TMT 165 FOUNDATION Fieldbus Betriebsanleitung Seite 155

FOUNDATION Fieldbus temperature transmitter
Index Parameter
21 SP_HI_LIM
22 SP_LO_LIM
19 SP_RATE_DN
20 SP_RATE_UP
1 ST_REV
Endress+Hauser
PID Function Block (PID controller)
Write access with
operating mode
(MODE_BLK)
ROUT - RCAS - CAS - Entry of the upper limit of the setpoint value.
AUTO -
MAN - OOS User input:
Factory default:
2
If the setting for the end of the scale is changed in the parameter PV_SCALE
this value should be modified accordingly.
ROUT - RCAS - CAS - Entry of the lower limit of the setpoint value.
AUTO -
MAN - OOS User input:
Factory default:
2
If the setting for the end of the scale is changed in the parameter PV_SCALE
this value should be modified accordingly.
ROUT - RCAS - CAS - Entry of the ramping rate of a diminishing setpoint value in operating mode
AUTO - AUTO.
MAN - OOS
Factory default:
2
• If the value '0' is entered then this parameter is deactivated and the
setpoint value is used directly.
• The speed restriction is only active in operating mode AUTO.
ROUT - RCAS - CAS - Entry of the ramping rate of an increasing setpoint value in operating mode
AUTO.
AUTO -
MAN - OOS
Factory default:
2
• If the value "0" is entered then this parameter is deactivated and the set-
point value is used directly.
• The speed restriction is only active in operating mode AUTO.
Static/read only Displays the revision status of the static data.
2
The revision status parameter is incremented on each modification of static
data.
Description
Range and unit of PV_SCALE ±10
100
Note!
Value and range of PV_SCALE ±10
100
Note!
+ INF
Note!
+ INF
Note!
Note!
11 Appendix
155