Operation; Vacuum Cleaning - Fakir S 200 electronic Bedienungsanleitung

Vacuum cleaning

WARNING!
Check the appliance and the power cable before use. A damaged appli-
ance may cause injury and may not be used.
3
2
1
4
2
5
1

Operation

Before using the appliance, check that all the filters and the
bag have been correctly inserted and that they are not da-
maged. The excellent filter quality is only achieved when the
filters are intact and correctly inserted.
Attach the required nozzle.
● Pull out the cable using the plug [1] to the required length.
● Press the foot button "On/Off" [2] to switch on the floor
vacuum cleaner.
● Set the required suction power:
Model S 200:
with suction power control [3] on.
Model S 250:
with the plus/minus touch button [4] the 5 levels are
shown by means of LED lamps [5].

NOTE!
The filter change display will shine when the bag or filter
is full or when the accessories are blocked (hose, tube,
nozzle).
In this case, change the bag or the clogged filter (see page
21-23) or remove the blockage.
When using the turbo-mattress brush or the crack nozzle, it
is possible that the filter change display lights up before the
bag or filter are full.
This is a technical feature and does not indicate that the
function is impaired.
The suction power
suction control. Use this control (slide) for short-term
reductions of the suction power.
For normal vacuum cleaning, you should keep this closed.
Use the suction power control for permanent reduction of the
suction power. This will allow you to save energy.
can be regulated
en
with the
19