EN
Floor/Carpet
Attachment
Floor Brush
Upholstery
Nozzle
Crevice
Nozzle
Hard floor
nozzle
Mounting the accessories
1. The appliance should be switched off and
unplugged .
2. Remove the nozzle from the telescopic tube.
3. When required, push the desired nozzle onto
the lower end of the telescopic tube or the handle.
ATTENTION!
Be sure that all filters were attached
correctly to the appliance before you
start cleaning. Filters must be
undamaged and dry. Uncompatibility
can damage your vacuum cleaner.
ATTENTION!
If you use the cylinder vacuum cleaner
without attached nozzle, there is a greater
risk of accidently vacuuming up objects.
1
4
18
Attachment use chart
Between Cushions Drapes
✓
✓
✓
3
5
Stairs
✓
✓
✓
✓
✓
Operation
1. Plug the suction hose adapter into the suction
hose receiver and lock the adapter by turning it
clockwise to the stop point.
2. Push the handle into the upperend of the
telescopic tube.
3. Push the floor nozzle/turbo brush onto the lower
end of the telescopic tube.
4. Adjust the length of the telescopic tube. To do
this, pres the telescopic tubelock forwards. Then
pull the telescopic tube by the handle to the
desired length. To lock it, release the telescopic
tube lock while you pull.
5. Pull the cable till you see the red mark on the
cable.
6. Switch on the cylinder vacuum cleaner using the
on/off switch.
7. Adjust the carpet/hard floor switch depending on
the type of flooring:
• Hard floor laminate flooring, tiles, PVC flooring,
etc. (with brush)
• Carpet long and short pile carpets, runners, etc.
(without brush)
8. To vacuum, pull the cylinder vacuum cleaner
behind you like a sledge.
Your divice has electronic power adjustment. You
can increase or decrease the vacuum power when
you would like.We advise you to keep the suction
power at midium/minimum level for carpet
cleaning, and at maximum level parquet and wet
floor cleaning.
Walls
Furniture
✓
✓
✓