Returning the Device
EN
10
Returning the Device
EN
Only return or package the devices after consulting R. STAHL!
EN
Contact the responsible representative from R. STAHL.
EN
R. STAHL's customer service is available to handle returns if repair or service is required.
EN
EN
Contact customer service personally.
EN
or
EN
EN
Go to the r-stahl.com website.
Under "Support" > "RMA" > select "RMA-REQUEST".
EN
Fill out the form and send it.
EN
You will automatically receive an RMA form via email. Please print this file off.
Send the device along with the RMA form in the packaging to
EN
R. STAHL Schaltgeräte GmbH (refer to chapter 1.1 for the address).
EN
EN
11
Cleaning
EN
Check the device for damage before and after cleaning it. Take damaged devices out of
EN
operation immediately.
EN
To avoid electrostatic charging, the devices located in hazardous areas may only be
cleaned using a damp cloth.
EN
When cleaning with a damp cloth, use water or mild, non-abrasive, non-scratching
EN
cleaning agents.
EN
Do not use corrosive cleaning agents or solvents.
EN
EN
12
Disposal
EN
Observe national and local regulations and statutory regulations regarding disposal.
Separate materials when sending them for recycling.
EN
Ensure environmentally friendly disposal of all components according to the statutory
EN
regulations.
13
Accessories and Spare Parts
NOTICE! Malfunction or damage to the device due to the use of non-original components.
Non-compliance can result in material damage.
Use only original accessories and spare parts from R. STAHL Schaltgeräte GmbH
(see data sheet).
12
I.S. Relay Module
Series 9172
160372 / 9172601310
2021-02-25·BA00·III·en·08