Assembling The Product; Setting Up The Product; Switching The Product On / Off; Replacing The Rechargeable Battery - Melinera IAN 352215_2007 Montage- Und Bedienungsanleitung

Assembling the product

WEAR PROTECTIVE GLOVES!
Wear protective gloves when assem-
bling and setting up the product!
10602A:
Connect the ground stake
(Fig. C).
Then push the ground stake
in the desired location.
Affix the lamp glass holder
and insert the glass lampshade
LED and solar panel
6
holder (Fig. C).
10
10602B:
Push the ground stake
the desired location.
Affix the lamp glass holder
stake and insert the glass lampshade
3
with the LED and solar panel
6
lamp glass holder
10
10602C:
Use with ground stake:
Attach the ground stake
housing (Fig. A).
1
Push the ground stake
desired location.
Tabletop use:
Set the product with solar cell housing
a level, even surface.
Deck / balcony use:
Insert the cable tie
. Make sure the eyelet of the cable tie
11
facing up (Fig. A).
Attach the cable tie
railing (Ø max. 8 cm) with the retaining pin
facing up (Fig. A).
Attach the product with solar cell housing
to the retaining pin
to the extensions
3
into the ground
3
to the extension
10
with the
2
into the lamp glass
5
into the ground in
3
to the ground
10
2
into the
5
(Fig. C).
to the solar cell
3
into the ground in the
3
on
1
through the retaining pin
12
12
to the deck / balcony
12
.
11

Setting up the product

Make sure it is firmly positioned. Do not use force
when assembling or setting up the product, e.g.
hammer blows. This will damage the product.
In order to get the best possible results, place
the product in a place where the solar cell is ex-
posed to direct sunlight for as long as possible.
4
Push the assembled product far enough into the
ground (grass, flower bed) to be stable. Please
note the assembly steps in the chapter "Assem-
bling the product".
4
Make sure the solar cell is not impacted by other
light sources, e.g. yard or street lighting, or the
light will not switch on at dusk.
The light will automatically switch on in low light
and switch off in normal daylight.

Switching the product on / off

Slide the on / off switch
to turn the product on.
Slide the on / off switch
to turn the product off.
Replacing the
rechargeable battery
10602A / B:
Remove the solar cell housing
the glass lampshade
holder .
10
Slide the on / off switch
Open the battery cover
screwdriver to remove the screws (Fig. D).
is Remove the rechargeable battery
it with a new rechargeable battery of the same
type AA or AAA (Fig. E+F).
Place the battery cover
11
cell housing
Then reinsert the screws and tighten them.
1
Slide the on / off switch
(Fig. G).
Replace the solar cell housing
the glass lampshade
holder .
10
to the "ON" position
9
to the "OFF" position
9
, including
1
, from the lamp glass
2
to the "OFF" position.
9
. To do this, use a
8
and replace
7
back on the solar
8
. Be careful with the wiring.
1
to the "ON" position
9
, including
1
, in the lamp glass
2
GB/IE 17