Storage When Not In Use; Troubleshooting - Crivit CEK 22 A1 Bedienungsanleitung Und Sicherheitshinweise

Crivit CEK 22 A1
Clean the inside of the coolbox with washing-up liquid and then rinse out with clean water. Then
dry the coolbox off thoroughly.
After cleaning, replace the lid [2] by moving it towards the coolbox in an upright position. Place the
lid [2] first into the left-hand opening and then push it down into the right-hand recess [7].

9. Storage when not in use

If you do not wish to use the coolbox for an extended period, remove all contents. Disconnect the
coolbox from the power supply and store the connection cable in the cable box [3]. Store the
coolbox in a clean, dry place out of direct sunlight. Leave the lid [2] open when in storage to
ensure the coolbox is well ventilated. You can hold the lid open [2] using the lock [6].

10. Troubleshooting

The coolbox does not work.
 Check that the cigarette lighter plug [1] is correctly inserted into the cigarette lighter socket.
 Switch on your vehicle ignition as many vehicles only supply electricity to the cigarette lighter
socket when the ignition is on.
 The fuse [8] is faulty. Replace the fuse [8] by following the instruction in chapter "8.2 Replacing
the fuse".
The coolbox is not cooling properly.
 Move the coolbox to a cooler position. Make sure that the coolbox is not exposed to direct
sunlight.
 Make sure that the ventilation slots are not covered and there is sufficient room for air to
circulate.
The coolbox is not warming properly.
 Make sure that the ventilation slots are not covered and there is sufficient room for air to
circulate.
26 - English