Cross Tools CPG 5500 NEV Original-Gebrauchsanweisung Seite 28

No liability is assumed for damages caused due to non-compliance with these instructions.
You are required to read the operating instructions before using the device for the first time.
In case of doubts regarding the connection and operation of the device, contact T.I.P. Tech-
nische Industrie Produkte GmbH. Please note that our devices have not been intentionally
designed for commercial, handicraft-related or industrial use. We do not assume any warran-
ty if the device is used in commercial, handicraft or industrial companies as well as for corre-
sponding activities.
4.7. Risks and scope of prevention
Risk Description
Direct electrical Direct electrical contact with wet
contact hands can cause electrical shocks.
Burns Touching the exhaust can cause
burns.
Hearing impair- Prolonged stay near a running gen-
ments erator can cause hearing impair-
ments.
Contact, inhalation Inhaling exhaust fumes can be fatal! Never operate the device in
Fire or explosion The fuel of the device can catch fire. Never operate in inflammable en-
Environmental haz- Leaking of oil and fuel damages the
ards environment.
Breakage during If the device is operated on a sloping
operation surface, lubrication is not ensured
and the device can be damaged.
4.8. Generator circuit breaker
The generator is equipped with a combined thermal/magnetic circuit breaker. This circuit
breaker allows higher currents to pass for a short period of time in order to allow 3-phase
motors to start up. If the load is higher than the permitted value for a longer period of time,
the circuit breaker disconnects the load from the generator. For this reason, check before
first use whether the load connected lies within the permissible range as the circuit breaker
could disconnect the load from the network after a certain time in order to protect the genera-
tor from overloading.
5. Assembly instructions
5.1. Assembly for mobile use
Take the CPG 5500 NEV out of the packaging and set
it down at the intended assembly site. The machine
must be horizontal. Remove dirt and dust so that the
air cooling of the generator cannot draw in any foreign
objects.
You should have the following aids at hand for instal-
lation:
2 x spanners (size 10)
2 x spanners (size 13)
1 x needle-nosed pliers
Fit the support feet and the wheels (the required parts can be found under section 3, page 2).
26
Translation of the original operating instructions
Prevention
Avoid contacting the device with
wet hands and make sure the de-
vice has appropriate grounding.
Let the devices cool down after
operation.
Always wear ear protection.
closed rooms.
vironment. Never refuel when en-
gine is running. No smoking.
Avoid leakage of these substanc-
es and use collecting trays during
maintenance.
Always operate on a flat surface.
4
7