Operation - Blumfeldt Tofino Bedienungsanleitung

EN
28

OPERATION

Before igniting the appliance, perform a leakage testing in a well-ventilated
area (outdoor). At first use and after every LPG cylinder substitution, the appli-
ance gas circuit must be purged of the inside air before igniting! To do this, turn
the control knob counter-clockwise to the ignition position and push it holding
for 1 minute before attempting ignition.
1. Make sure that LPG cylinder, full 4/5 its capacity, contains proper LPG Gas
(refer to Technical Data on page 2). Turn LPG cylinder valve in full "ON" po-
sition and close LPG compartment panel.
2. Make sure that burner control knob is in "OFF" position (full disk).
3. Push the control knob and keep pressing while turning counter-clockwise
to the corresponding low position (small flame). At the same time push the
ignition button. Igniter will sparks automatically (it is possible to ignite the
appliance even with proper lit long match, approaching carefully the burner
managing in the same way).
4. When the burner is lit in low position (small flame), stop pushing ignition
button and keep the control knob pressed but not over 15 seconds to heat
the thermocouple (FSD); then release it (first ignition take generally more
time, because gas circuit is full of air).
5. If the burner does not keep lit, wait 1-2 minutes and then repeat steps 3
and 4.
6. Burner now is lit in Minimum position (small flame).
7. Adjust the heat input by turning the knob from the Minimum position (small
flame) to the Maximum position, as properly.
8. After lighting, turn knob from Minimum to Maximum (big flame) position
and back, to check flame stability.
9. In case of accidental break down of the flame (for wind or other reasons),
FSD will shout-off gas supply automatically (FSD = Flame Safety Device)
not over 60 seconds.
Note: The burner may be noisy when initially turned on. If you experience any
ignition problem consult the following "Troubleshooting".