Installation; Powering On; Antenna Settings - SMART CX03 Bedienungsanleitung

3. Installation

You should install the receiver when powering on your product for the first time
after purchase.
Tip: The default password is 0000. If you have forgotten your password, please
contact your local product distributor.

3.1 Powering On

1. Connect the power cord of the product to a wall outlet.
2. Power on by pressing the STANDBY button on the remote control or the
STANDBY button at the front of the product.

3.2 Antenna Settings

Antenna Settings allows you to configure the antenna setting parameters.
Menu->Installation->Antenna Settings
1. Satellite: Highlight the satellite you want to search.
2. Transponder: Press the / button to
change the TP.
3. LNB Type: / button to
change the LNB frequency.
4. LNB Power: Press the / button to
select the required LNB power.
5. 22kHz: Press the / button to select
ON, OFF or Auto.
6. DiSEqC1.0: Press the / button to
select the required DiSEqC1.0 input.
7. DiSEqC1.1: Press the / button to
select the required DiSEqC1.1 input.
8. Motor / button to select DiSEqC1.2 or USALS.
9. Scan Mode: Press the / button to select scan mode.
10. Start Search: Press the / button to select Satellite & Multi-Sat & Blind
scan & Transponder & Multi-Transponder which you want to start search.
23