Cd Encoding - auna DS-2 Bedienungsanleitung

EN
34
After the program is complete, press "skip up
(2) to review the tracks being programmed. Press " stop
at CD stop mode to cancel all programmed memory. For mp3 disc / file,
press the " folder / pre-up " button (16) to select the 1st track of next folder
directly and hence to speed up the song slection. The programming model
will automatically stop if no button is being pressed in a period of about 10
seconds after pressing the " mem/clk-adj " button (17).Encoding of CD and
phono
The system is able to encode normal CD or turntable to mp3 format and
recording at memory media with USB connecting port. Before starting the
encoding, please insert the memory media (USB pen drive) to the system &
make sure it had adequate free memory size for recording.

CD ENCODING

Ecnoding 1 track / 1 disc
8. Perform normal playback of the CD track you want to encode & record.
9. Press " rec" button (3) during the playback of the desire track and the
system will start encoding.
10. The system will show "
performing now.
11. Press the " rec" button (8) repeatly again to select record 1 track "
rec_one " or record one entire disc "rec_all ".
12. After completing of recording, unit will stop playback automatically.
Encoding by program
1. Place a CD with the printed side facing up inside the tray & then close
the co door
2. Select the desire tracks by following " CD disc programming "
procedures. Then press " CD play/pause " button (14) to start playback
3. Press the " rec" button (8) and the unit will display "
flashing. Encoding is now performing.
4. Press the " rec" button (8) repeatly again to select " rec_all ".
5. After completing of encoding according to the preset program, unit will
stop playback automatically.
Hints on encoding
• The recording speed is 1:1 and according to the actual plying time of the
CD track
or down
" & "rec" and flashing. Encoding is
" button
" button (14)
" & " rec" and