Shark IQ ROBOT SELF-EMPTY RV1000SEU Gebrauchsanweisung Seite 23

MAINTENANCE
CLEANING AND REPLACING THE ROBOT FILTER
For best results, regularly clean and replace the filter in the robot. See sharkclean.eu
for replacement filters.
IMPORTANT: DO NOT use water to clean the robot filter.
Remove and empty the robot dustbin. Clean any
hair or debris off the Anti-Tangle Comb on the
back of the dustbin.
Lightly tap the filter to remove dust and debris.
NOTE: Make sure to insert the dustbin completely, until it clicks into place.
s h a r kc l e a n . e u
Pull filter out of the dustbin by the tabs.
Reinsert the filter into the robot dustbin, then slide
the dustbin back into the robot.
MAINTENANCE
CLEANING AND REPLACING THE BASE FILTERS
For best results, regularly clean and replace the filters in the base.
To clean filters, rinse with cold water ONLY to prevent damage from cleaning chemicals. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.
IMPORTANT: DO NOT use soap when cleaning the filters.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top right edge
of the base and pull up on the lid. With the lid open,
remove the foam filter by the top handle, then lift out
the felt filter underneath. Tap the filters clean over the
rubbish bin, then rinse them with cold water ONLY,
as soap may damage them. Allow filters to air-dry
completely before reinstalling them.
The filters must be installed correctly for the base
to work properly. Reinsert the felt filter first, then the
foam filter.
NOTE: The pre-motor foam and felt filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
NOTE: Clean the mesh filter inside the dustbin with a small brush once a month.
Filter
Door
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the Filter Door, then
tilt the door and lift it off. Remove the Post-Motor
Filter from the base. To reinstall the post-motor
filter, insert it into the base and replace the filter
door.
s h a r kc l e a n . e u