Shark IQ ROBOT SELF-EMPTY RV1000SEU Gebrauchsanweisung Seite 19

IMPORTANT: The Shark iQ Robot Self-Empty® has a pre-installed rechargeable battery. Charge the battery
completely before using the robot. It may take up to 6 hours to fully charge.
To charge, place the robot with its BACK side against
the base. The metal Charging Pads on the bottom of
the robot must be touching the Charging Contacts on
the base. Make sure the power switches on BOTH the
robot and the base are turned to the (I) ON position.
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the base. If your
robot doesn't return to the base, its charge may have
run out. Make sure that all the protective film has been
removed from the base, and recharge the robot
NOTE: When manually placing the robot on the base, make sure the charging contacts on the bottom of the robot are
touching the ones on the base and the robot's dustbin is touching the debris intake on the base. When the robot is fully
charged, the battery light on the robot and the indicator light on the base will both turn solid blue.
NOTE: When picking up the robot be careful not to place fingers between the bumper and the base of the robot.
s h a r kc l e a n . e u
CHARGING
When charging begins, the robot will beep. The BLUE
Charging Indicator Light on the base will PULSE, and
the Battery Indicator Light on the robot will flash
blue. When the robot is fully charged, the battery light
on the robot and the blue charging indicator light on
the base will illuminate steadily.
If the robot has no charge and cannot return to
the base, manually place it on the base. When the
robot evacuates dust and debris into the base,
the blue light on the base will be solid blue. Once
charging starts, the robot will beep and the blue
light on the base will pulse.
ROBOT BATTERY INDICATOR LIGHT
The battery indicator light on the robot shows how much charge is remaining. When the robot is charging, the
battery light will flash blue. When charging is complete, the light will illuminate steadily in blue.
NOTE: If the battery indicator light on the robot is blinking red, there is not enough charge for the robot to return to the
base. Manually place the robot on the base.
BASE INDICATOR LIGHTS
There are 2 indicator lights on the front of the base, the green power indicator light and the blue charging
indicator light. When the base is plugged in and the power switch is turned on, the GREEN power light
illuminate. When the robot is charging on the base, the BLUE light will pulse. When charging is complete, the
blue light will illuminate steadily.
ROBOT BATTERY INDICATOR LIGHT
In Use
Full Partial Low
Charge Charge Charge
(Blue) (Blue) (Red)
While
Charging
(Blue)
No Charge
or Off
Power
Indicator Light
Charging
Indicator Light
s h a r kc l e a n . e u
will