Intended Use; Power Supply - Makita DP3003 Betriebsanleitung

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Drilling capacities
No load speed
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014

Intended use

The tool is intended for drilling in wood, metal and
plastic.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-1:
Model DP3003
Sound pressure level (L
Sound power level (L ) : 92 dB (A)
WA
Uncertainty (K) : 3 dB(A)
Model DP4001
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Model DP4002 / DP4003
Sound pressure level (L
Sound power level (L ) : 93 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Steel
Wood
) : 81 dB(A)
pA
) : 80 dB(A)
pA
) : 82 dB(A)
pA
DP3003 DP4000
10 mm
32 mm
-1
0 - 1,200 min 0 - 950 min
296 mm 304 mm
2.2 kg 2.5 kg
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-1:
Model DP3003
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DP4001
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DP4002 / DP4003
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) may also
be used in a preliminary assessment of exposure.
4 ENGLISH
DP4001 DP4002
13 mm
38 mm
-1
0 - 700 min
308 mm 304 mm
2.4 kg 2.7 kg
/II
2
) : 2.5 m/s or less
h,D
2
2
) : 8.5 m/s
h,D
2
2
) : 5.0 m/s
h,D
2
DP4003
-1
308 mm
2.5 kg