Operation Instructions - Klarstein ICETOWER SMART Bedienungsanleitung

EN
18

OPERATION INSTRUCTIONS

1. Place the tower fan on a stable flat surface. Plug the power cable into a
220V-240V~ electrical outlet.
2. ON/OFF: Turn the FAN on by pressing the 'ON/OFF' button, turn the FAN off by
pressing the 'ON/OFF' button again.
3. When switched on, the unit will first operate in low speed, normal mode.
4. SPEED: You can adjust the fan speed to the desired level: Low, Medium, or High
by pressing 'SPEED' button.
5. MODE: Pressing the 'MODE' button will set the FAN into NORMAL,NATURAL or
SLEEP mode.
a. Normal mode: The fan operates in normal function at the selected speed
without change.
b. Natural mode: The fan motor will run to the pre-programmed procedure to
work irregularly, the speed runs through continuous cycles low - medium - high.
c. Sleep mode: When you select the sleep mode at low speed, the device
operates continuously at low speed.
When you select the sleep mode at medium speed, the unit will operate at medium
speed for around half of an hour, and then the unit will operate at low speed.
When you select the sleep mode at high speed, the unit will operate at high speed for
around half of an hour, then operate on medium speed for another half of an hour, and
then change to low speed.
6. TIMER: Press this button to set the running time of the fan. The fan can be adjusted
from 1 hour to 12 hours. Pressing the button once will set the timer at 1 hour, press
the button twice and the timer will set at 2 hours and so on until a maximum of 12
hours can be set.
7. SWING: Press this button once to start the Swing function, press a second time to
stop the Swing function.