Herunterladen Inhalt Inhalt Diese Seite drucken

Safety Instructions - Klarstein SKYSCRAPER 2G Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für SKYSCRAPER 2G:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
EN
12
All manuals and user guides at all-guides.com

SAFETY INSTRUCTIONS

Packaging materials (plastic bags, polystyrene, staples etc.) Must be kept out
of the reach of children as they could be hazardous.
Children over the age of 8 and persons with reduced physical, sensory or
mental capabilities or those with a lack of experience and knowledge may only
use the device if they are instructed on how to do so by a person responsible
for their safety, or if they are supervised and understand the hazards
associated with the use of the device. Children may not clean or carry out user
maintenance without supervision.
Do not leave the appliance unattended.
Before connecting the appliance, check that the appliance rating corresponds
to the mains rating.
This appliance must only be used for the purpose for which it has been
manufactured. As a stand fan. The manufacturer is not responsible for any
damage caused by improper or incorrect use.
The installation/assembly of the device will be made according to the
indications of the manufacturer. A wrong procedure may cause damages to
persons, animals or objects, for which the manufacturer cannot be considered
responsible.
Before cleaning or carrying out maintenance on the appliance, disconnect it
from the electrical mains by removing the plug from the electrical outlet or by
switching off the system switch.
The appliance is not to be used if there are signs of damage. If the appliance
is faulty and/or operating incorrectly, switch it off without tampering with it. If
the above is disregarded, the safety of the appliance may be compromised.
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
Do not power the device using multiple sockets.
Do not use adapters and/or extension cable.
The device must not be switched on using external timers and/or other
remote control devices which are not specified in this manual.
Do not use or store the device near heat sources (heaters, stoves).
Do not dip the device in water or other liquids; in case the accidental fall in the
water do not try to take it out, but first of all unplug immediately the power
cable from the socket.
If you use the device for the first time, make sure to remove any label or
protective sheet which blocks its proper functioning.
Do not pull the plug out of the socket by the cable, but hold it firmly by hand
when pulling it off.
Before plugging the plug into a wall outlet, make sure that the unit is switched off.
Always unplug the power cable to avoid the overheating and avoid stretching it.
Make sure that all air intakes and outlets are free and not covered so that the
unit does not overheat.
Avoid placing the power cable on abrasive or sharp surfaces or in positions
where it can be damaged easily.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

100279441002794610027947

Inhaltsverzeichnis