Starting The Dc Power Unit; Checking The Charge Level Of The Battery Pack; Stopping The Dc Power Unit; Removing The Battery Pack - Honda GXE2.0H Bedienungsanleitung

STARTING THE DC POWER UNIT

GXE2.0H
Refer to the equipment manual for instructions to start the DC
Power Unit.
GXE2.0S
See figure 3 on page IV.
1. Press STOP on the START/STOP switch.
2. Press the POWER button.
All the indicators should illuminate for a few seconds, and
then only the POWER indicator remains illuminated.
3. Press the START/STOP switch to the START position to start
the DC Power Unit.
4. Push the SPEED CHANGE button to set the DC Power Unit
speed as required.
• If the POWER button is pressed when the START/STOP
switch is in the START position, the POWER indicator
remains off and the ALERT indicator flashes. In this case, the
DC Power Unit cannot start. Press the START/STOP switch to
the STOP position and then press the POWER button.
• It may take some time for the indicators to light after the
POWER button is pressed. If the indicators do not light,
press the POWER button again.
• If the DC Power Unit is not operated for about one minute
after the POWER button is pressed, the POWER indicator
turns off. Press the POWER button again to start the DC
Power Unit.
CHECKING THE CHARGE LEVEL OF THE BATTERY
PACK
While the DC Power Unit is operating, the charge level
indicator lights or flashes so you can confirm the charge level
of the Battery Pack.
While the DC Power Unit is stopped, press the charge level
check button to confirm the charge level of the Battery Pack.
See figure 4 on page V.
Indicator Display
High
Low
: On, : Flashing, : Off
Charge Level
Fully charged.
Sufficiently charged.
Remaining battery power is
low.
Charge the Battery Pack.

STOPPING THE DC POWER UNIT

GXE2.0H
Refer to the equipment manual for instructions to stop the DC
Power Unit.
GXE2.0S
See figure 3 on page IV.
1. Press the START/STOP switch to the STOP position.
The DC Power Unit stops and the POWER indicator turns off.
• You can also stop the DC Power Unit by pressing the POWER
button, but it may take some time to stop.

REMOVING THE BATTERY PACK

1. Remove the power cable from the Battery Pack.
2. Pull the battery fastener down to unlock, tilt the Battery
Pack up and pull the Battery Pack claw out from the battery
hook, and remove the Battery Pack.
3. Attach the battery connector cap to the power cable.
3