Installation Instructions; Important Safety Information - CONSTRUCTA CD619650 Gebrauchs- Und Montageanleitung

INSTALLATION INSTRUCTIONS

Installation instructionsI n s t a l l a t i o n i n s t r u c t i o n s

: Important safety information

Read these instructions carefully. Only then
will you be able to operate your appliance
safely and correctly. Retain the instruction
manual and installation instructions for
future use or for subsequent owners.
Check the appliance for damage after
unpacking it. Do not connect the appliance
if it has been damaged in transport.
The appliance can only be used safely if it
is correctly installed according to the safety
instructions. The installer is responsible for
ensuring that the appliance works perfectly
at its installation location.
Caution!
Damage to the appliance: The surfaces of
the appliance are sensitive. Avoid dama-
ging them during installation.
The width of the extractor hood must
correspond at least with the width of the
hob.
For the installation, observe the currently
valid building regulations and the regulations
of the local electricity and gas suppliers.
20
This appliance is installed on the wall.
■
Follow the enclosed installation instructions for additional
■
special accessories (e.g. for circulating-air mode).
The surfaces of the appliance are sensitive. Avoid damaging
■
them during installation.
f o r m a t i o n I m p o r t a n t s a f e t y i n
Risk of fire!
Fatty deposits in the grease filter may catch
fire. The specified safety clearances must
be complied with in order to prevent a build-
up of heat. Refer to the information provi-
ded for your cooker. If gas and electric
hobs are being operated together, the lar-
gest specified clearance applies.
Risk of fire!
Grease deposits in the grease filter may
catch fire. Never work with naked flames
close to the appliance (e.g. flambéing). Do
not install the appliance near a heat-produ-
cing appliance for solid fuel (e.g. wood or
coal) unless a closed, non-removable cover
is available. There must be no flying sparks.
When conveying the exhaust air, official and
legal regulations (e.g. state building
regulations) must be followed.