Cleaning Agents - CONSTRUCTA CD619650 Gebrauchs- Und Montageanleitung

Cleaning agents

To ensure that the different surfaces are not damaged by using
the wrong cleaning product, follow the instructions in the table.
Do not use any of the following:
Harsh or abrasive cleaning agents, e.g. scouring powder or
■
liquid scouring cleaner,
Cleaning products with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
Pressure washers or steam cleaners,
■
Cleaning products that dissolve limescale,
■
Aggressive all-purpose cleaning products,
■
Oven spray.
■
Note: Wash new sponge cloths thoroughly before use.
Note: Follow all instructions and warnings included with the
cleaning products.
Area Cleaning products
Stainless steel Hot soapy water:
Clean with a dish cloth and then dry with
a soft cloth.
Clean stainless steel surfaces in the
direction of the grain only.
Special stainless steel cleaning prod-
ucts are available from our after-sales
service or from specialist retailers.Apply
a very thin layer of the cleaning product
with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and then
dry with a soft cloth.
Do not use stainless steel cleaner.
Aluminium and Hot soapy water:
plastic Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Controls Hot soapy water:
Clean using a damp dish cloth and then
dry with a soft cloth.
Risk of electric shock caused by pene-
trating moisture.
Risk of damage to the electronics
caused by penetrating moisture. Never
clean controls with a wet cloth.
Do not use stainless steel cleaner.
--------
18
Removing metal grease filter
1. Open the lock and swing down the metal grease filter. When
you do this, take hold of the metal grease filter from
underneath with your other hand.
Take the metal grease filter out of the holder.
2.
Notes
Fat may accumulate in the bottom of the metal grease filter.
■
Hold the metal grease filter level to prevent fat from
■
dripping out.
Cleaning the metal mesh grease filters
These instructions apply to several appliance variants. It is
possible that individual features are described which do not
apply to your appliance.
:
Risk of fire!
Fatty deposits in the grease filter may catch fire. Regularly
clean the grease filter. Never operate the appliance without a
grease filter.
Notes
Do not use aggressive, acidic or alkaline cleaning products.
■
We recommend cleaning the grease filters every 2 months.
■
When cleaning the metal grease filters, also clean the metal
■
grease filter holder in the appliance using a damp cloth.
The metal grease filters can be cleaned in the dishwasher or
■
by hand.
By hand:
Note: You can use a special degreaser to remove stubborn
dirt. This can be ordered from the online shop.
Soak the metal grease filters in hot soapy water.
■
Clean the filters with a brush and then rinse them thoroughly.
■
Leave the metal grease filters to drain on an absorbent
■
material.
In the dishwasher:
Note: Slight discolouration may occur if the metal grease filters
are cleaned in the dishwasher. This discolouration has no effect
on the performance of the metal grease filters.
Use normal domestic dishwashing detergents.
■
Do not clean heavily soiled metal grease filters together with
■
cookware.
Place the metal grease filters in the dishwasher, leaving
■
plenty of space around them. Do not trap the metal grease
filters.
Select a temperature of no more than 50 °C.
■